Be sure you know which one is the SD card. It might not necessarily be the last one in the list. The SD card will be the one that just showed up. Make a note of the size of the disks listed, and then insert the SD card and run it again. If you are unsure, close DiskPart and remove your SD card, then load it back up and run “ list disk” again. In the above example I can see that Disk 0 and Disk 1 are the disks in my PC, as the sizes relate to the size of my C: and D: drives.ĭisk 5 is my SD card, as it is roughly the size of the 16GB card in my card reader. If you select the wrong disk, you might damage your OS and have to reinstall or repair it. You need to identify which of the listed disks is your SD card. This is the only step in this guide where you need to be a little bit careful. SELECTING THE CORRECT SD CARD IN DISKPART Start by typing “ list disk” and taking a look at the output. You will then be presented with the DiskPart utility screen, which is the command line interface we will use to format the SD card. If you’ve ever inserted an SD card from an Anbernic device into a Windows PC, you’ll likely be familiar with this error message.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |